FAQs
What is the approximate life of a set of tyres?
The life of your tyres depends on several factors: the condition of your vehicle and the roads, you drive on, driving habits, etc.
Must all the tyres on my car be the same kind?
Steel Belted radials are the best type of tyre for your vehicle. As far as possible avoid mixing them with any other kind of tyre. And if you have to mix tyres, NEVER mix a radial tyre with a bias ply/ conventional tyre on the same axle. Tyres come in different sizes. Make sure that your tyres match the size recommended by your automobile manufacturer. Or use the automatic tyre selector to determine which tyres are best suited to your car.
What is the recommended inflation pressure for my tyres?
The inflation pressure of your tyres varies depending on the tyre size and the kind of car you drive. Check the inflation chart for the optimum inflation pressure for your car.
Remember that all Radial tyres, by the nature of their construction appear to be under-inflated. Hence do not inflate them beyond the recommended pressure. Improper inflation can result in uneven tyre wear and even premature tyre/ tube failure. Always check inflation pressure when the tyres are cold.
How are tyres mounted on wheel?
Correctly mounting a tyre can increase their life span. Here's how it is done: Inspect and clean wheel rims before mounting a new tyre. Ensure all bead seats are completely free of dirt and rust. Remove old wheel weights. It is advisable to replace your wheel rim if a flange is bent.
Always lubricate the tyre beads before mounting, with a mild soap-and-water solution to prevent them from being damaged. Do not use grease or oil to lubricate the beads. Ensure that the beads are properly seated in the rims once the tyre has been fitted.
Is it necessary to check the balance and alignment of my wheels?
Yes it is. Electronic balancing of wheels prevents uneven tyre wear that is caused by unbalanced wheels. Ideally, balancing and alignment should be checked every 5000-7000 kms. However, if you are driving on bad roads, it is advisable to check the alignment and balance more often.
Are tubes for Radial tyres different from tubes for ordinary nylon tyres?
Yes. Radial tubes are harder and retain air better. They are built to withstand a higher rate of deflection.
Isn't it easy to mount a tire on a wheel? Can't I do it myself?
Never try to mount your own tires. Tire mounting is a job for the people who have the proper equipment and experience. If you try to do it yourself, you run the risk of serious injury to yourself as well as possible damage to the tire and rim.
What is alignment?
A vehicle is said to be properly aligned when all suspension and steering components are sound and when the tire and wheel assemblies are running straight and true. Proper alignment is necessary for even tread wear and precise steering. Uneven front-or rear-tire wear, or changes in your vehicle's handling or steering response (i.e. pulling to one side) can indicate misalignment. Many vehicles today are equipped with rear suspensions that can be adjusted for alignment. Your vehicle may need a "front-end" alignment or a "four-wheel" alignment, depending on the symptoms you are experiencing. The moderate cost of having your vehicle aligned can more than pay for itself in tire mileage, performance and comfort. Goodyear retailers provide expert alignment and suspension service.
What should I do if I notice a vibration?
Vibration is an indication that your car has a problem that needs attention. The tires, steering system and suspension system should be checked to help determine the possible cause and correction of the vibration. If left unattended, the vibration could cause excessive tire and suspension wear. It could even be dangerous. Goodyear retailers offer expert diagnosis and repair.
Why do my tires need to be balanced?
Properly balanced tires are important for driving comfort and long tire life. Unbalanced tires can cause vibration, resulting in driver fatigue, premature tire wear and unnecessary wear to your vehicle's suspension. Tires should be balanced when they are mounted on wheels for the first time or when they are remounted after repair. Tires should be rebalanced at the first sign of vibration or "shimmy." Vibration may also be due to misalignment or mechanical problems. Many Goodyear retailers can provide expert diagnosis and repair
How do I know when I need new tyres?
Many tyres have tread wear indicator bars molded into the tread. When the tread is worn down to where you can see a solid bar of rubber across the width of the tread, it is time to replace the tyre. Here's another simple test you can perform to measure tread depth on your tyres. Place a penny into a tread groove with Lincoln's head upside down and facing you. If you can see the top of Lincoln's head, it's time to visit a Goodyear retailer for a new tyre.
Must I replace my present tyres with the same size tyres?
Never choose a smaller size than those that came with the car. Tyres should always be replaced with the same size designation -- or approved options -- as recommended by the vehicle manufacturer.
Should I "mix" tyre types on my car?
Tyres of different size designations, constructions, and stages of wear may affect vehicle handling and stability. For best all-around performance, it is recommended that all tyres be of the same size, construction (radial, non-radial) and speed rating.
When buying just two new tyres, should they be put on the front or rear?
When radial tyres are used with bias or bias belted tyres on the same car, the radials must always be placed on the rear axle. Never mix radial and bias-ply tyres on the same axle. When you select a pair of replacement tyres in the same size and construction as those on the car, we recommend you put them on the rear axle. A single new tyre should be paired on the rear axle with the tyre having the most tread depth of the other three.
